?unique=3001d2d)
KÖSTER Crisin 76 Concentrate
DESCRIPTION
KÖSTER Crisin 76 is a very thin, solvent free, concentrated liquid synthetic resin. It penetrates deeply into even the smallest capillaries and pores in building materials. Due to its very low density and a surface tension lower than that of water, KÖSTER Crisin 76 displaces the water in the capillaries. Capillaries lined with KÖSTER Crisin 76 are lined with resin and hydrophobic. The curing of the injected product is independent of the drying of the masonry. After full cure, KÖSTER Crisin 76 remains flexible, does not decay or decompose, acts neutrally, does not effloresce, and does not affect steel reinforcement. During application and after full cure, KÖSTER Crisin 76 is resistant to all of the usual corrosives in masonry such as acids, alkalis, and salts.
AREAS OF APPLICATION
For saturation and pressureless injection for creating subsequent horizontal waterproofing against capillary rising moisture in all mineral building materials. Can be applied from inside and/or outside. Can be applied in cases of high degrees of moisture penetration (tested up to 95% Moisture Content) and with all degrees of salt contamination.
PROPERTIES
Moisture Resistance:
Suitable even in cases of high moisture content (up to 95% ± 5%)
No prior or subsequent wall drying required, even under high moisture conditions
Salt Resistance:
Suitable for high salt content
Effective against most common salts (sulfates, nitrates, chlorides)
Chemical and Physical Properties:
Solvent-free
Not water-soluble / Cannot be diluted with water
Resistant to acids, alkalis, and salts typically found in masonry
Not bio-degradable
Does not cause or promote corrosion of steel reinforcement
Density: 0.91 g/cm³ – penetrates deeply into even the smallest capillaries
Cures into an elastic resin that deposits on pore walls and mechanically blocks pores
Application Advantages:
Fast-acting, immediately effective
Does not require the substrate to be alkaline
Can be applied without filling voids, even in perforated brick and cracked or hollow masonry
One-time installation, no subsequent injection needed
Easy to install with horizontal drilling
Access required only from one side of the wall
Environmental and Safety Aspects:
Made from renewable raw materials
Certifications and Guarantees:
Patented system
Proven effective for over 30 years
10-year warranty*
*Provided application is performed by a certified applicator
CONSUMPTION
Guide value: 0.04 l / m per cm wall thickness Refer to last page for consumption table.
PACKAGING
M 279 005 5 l jerrycan
M 279 010 10 l jerrycan
M 279 030 30 l jerrycan
M 279 200 200 ml cartridge
Please note: KÖSTER Bauchemie AG products are available for sale only on the Estonian market.
Specyfikacja
| Salespackaging | 5 l, 10 l, 200 ml, 30 l |